If it's your first time installing a wrap, don't be discouraged if it's not flawless right away. Stand back and admire the transformation – your boards are now ready to steal the spotlight at every game! Take your time to get clean cuts.įinal Squeegeeing: Go over the entire wrap once more with the squeegee, paying extra attention to edges and corners.Ĭongratulations! You've successfully installed a cornhole wrap. Trim Excess: Once the wrap is fully applied, use a sharp knife or blade to trim the excess wrap along the edges of the board. This makes it more pliable and helps with conforming to the contours of the board. Heat and Stretch: As you move along, use a heat gun or hair dryer to warm the wrap. Use the squeegee to smooth out the wrap and push out any air bubbles. Start Squeegeeing: Starting from the taped edge, slowly peel off the backing of the wrap while gently squeegeeing the wrap onto the board. You might want to check the design's orientation, especially if it's directional. Use masking tape to secure one edge of the wrap to the board.Ĭheck Alignment: Step back and make sure the wrap is properly aligned. Gather Your Tools: Have your squeegee, heat gun/hair dryer, masking tape, and ruler ready.Īlign the Wrap: Place the wrap on the board, aligning it according to your preferred position. A clean surface is crucial for a smooth application.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |